Mac mojave for 2013 macbook pro 13 upgrade#
Mac mojave for 2013 macbook pro 13 mac#

You may restore your previous installation from your Time Machine backup if you want, I usually do a fresh install. Choose the Disk Utility, find your new SSD and format it APFS with a GUID Partition Map.

Select the вЂInstall macOS CatalinaвЂ™ disk.

Mac mojave for 2013 macbook pro 13 mac#

Insert your bootable USB stick into the Mac and hold down the Option key while it boots.

Close up the laptop case, reversing the steps from the iFixit guide.Д¬onfiguring the Drive and Installing the Operating SystemДЄt this point you should be ready to perform a fresh installation of macOS 10.15.

Gently insert the new SSD and screw it into the motherboard without overtightening.

Attach your new SSD to the Sintech adapter and place a small strip of the Kaptop insulation tape across the adapter, as seen here.

With the case open, take the time to clean it with the compressed air and isopryl alcohol, itвЂ™s filthy in there.

Be careful not to strip the P5 and T5 screws. After all the upgrades have been applied, shut down your Mac and follow the relevant iFixit Mac Laptop Repair guide for removing the SSD from your laptop.This page lists the latest currently available firmware for each model. This is especially important if youвЂ™re upgrading from 10.13 or earlier releases.

Mac mojave for 2013 macbook pro 13 upgrade#

Before removing the original hard drive, do a complete upgrade of the macOS operating system to the latest version available (currently 10.15.1) to ensure that any firmware updates available to your machine are applied.

Make sure you have everything crucial backed up and saved before progressing.

Back up the machine with an external Time Machine drive.

Create a bootable USB macOS Catalina disk.

Once you have your parts in hand, here are the steps I followed to upgrade my systems to the latest version of macOS 10.15 вЂCatalinaвЂ™ with new SSDs. The Sintech NVMe M.2 adapter is considered to be the best and you can get them directly from Amazon. I used the Adata XPG SX8200 Pro 512GB 3D NAND NVMe Gen3x4 PCIe M.2 2280 Solid State Drive, but would consider the Sabrent 512GB Rocket NVMe PCIe M.2 2280 Internal SSD. Larger drives (1TB) appear to be a bit faster, I didnвЂ™t see much need to go beyond 512 gigabytes of storage and wanted to keep it relatively inexpensive. If you have a 15вЂќ Macbook Pro you may benefit from a faster SSD because of the PCIe 3.0 x4, but the rest of the models are limited by PCIe 2.0 x4 giving them a theoretical limit around 2,000 MB/second (results from the thread rarely get above 1500 MB/s with 13вЂќ models. There are a lot of options for which SSD to purchase, the general consensus from the MacRumors thread was that the Sabrent Rocket and Adata XPG SX8200 models provide the best price/performance results.

Heat resistant Kapton/Tesa/Sellotape insulation tape.

Isopryl alcohol for cleaning the aluminum laptop case.

Compressed air for cleaning out dust from the laptopвЂ™s internals.

I bought a Smart Phone Repair Kit here in Australia, you may want something similar from Amazon.

P5 Pentalobe and T5 Torx screwdrivers.

The iFixit Mac Laptop Repair guides provide excellent step by step instructions for SSD replacements specific to each model. Make sure you have the right equipment for performing the upgrade. These are the 2 machines I updated, named for Futurama characters. has thorough descriptions of each model, use About This Mac-> System Report to gather up all the details of your system. Take the time to figure out exactly which model you have before getting starting. The total cost was under $90 USD each for upgrading to 500 gigagbyte drives.

Go read at least the first page of that thread if you have questions I donвЂ™t answer, there are 220 pages of feedback so far. There is an amazingly thorough thread on this, but I figured IвЂ™d post my experiences upgrading 2 of my laptops that IвЂ™ve upgraded so far. Relatively recently (10.13) it became possible to upgrade these systems with an aftermarket adapter and stock NVMe M.2 form factor SSDs. The SSDs used by MacBook Air and MacBook Pros shipped between 2013-2017 used a proprietary adapter. Apple laptops are somewhat notoriously resistant to upgrades.